Upgrade ram mac mini a1176

Work delicately. During reinstallation, you will have to slightly squeeze the two posts together so they fit into the openings on the AirPort antenna board.

Mac mini Model A Repair

Use the tip of a spudger to slightly lift the left side of the ZIF cable lock up from its socket. The ZIF cable lock will lift about 1 mm and stop. Do not try to completely remove the ZIF cable lock. If it refuses to lift from its socket, the ZIF cable lock is not fully released. Make sure it is evenly lifted about 1 mm from the socket on the interconnect board. Use a pair of tweezers to lift the hard drive thermal sensor cable connector up off its socket on the logic board. Use tweezers to grab the connector as seen in the picture , not the wires.

The connector is located under the optical drive opening, next to the PRAM battery. In the next few steps, you will remove the four Phillips screws securing the internal frame to the bottom case. Included in each step is an overview picture showing the general location and a closeup showing the actual screw. Remove the recessed Phillips screw near the power button securing the internal frame to the bottom housing. Remove the recessed Phillips screw near the sleep light securing the internal frame to the bottom housing. This screw is the longest of the four screws securing the internal frame to the bottom case.

Remove the Phillips screw near the audio ports securing the internal frame to the bottom case. Gently lift the internal frame up from the bottom housing, minding the AirPort antenna and any other cables that may get caught. It may be necessary to pull up near the interconnect board to separate it from the logic board. Simultaneously pull the tabs on each side of the RAM chip away from the center of the chip.

These tabs lock the chip in place and releasing them will cause the chip to "pop" up. If there are two RAM chips installed, repeat the above procedure for the second chip. Cancel: I did not complete this guide.


  1. ws ftp mac os x.
  2. archicad 16 3487 mac crack.
  3. architecture floor plan software mac.
  4. mac mini 2012 bottom cover.

Badges: As a quick warning for noobs that'd be me before I attempted this repair :P , you need a matching pair of RAM two chips the same size and spec. Otherwise, the computer won't boot up. There were 2x 1GB chips in my mini. If I buy another 2GB chip, will it work? This was easier than it looked, the only thing I had trouble with was getting the cover off tried to use a flexible palette knife, bad idea and getting the little sensor plug back in it's SO tiny.

Oh, and one screw I had trouble getting back into the hidden recessed hole because my screwdriver isn't magnetized. Speaking of which, size of screwdriver matters, I bought a set with a size 0 and size , but no 00, neither worked. Fortunately I had one of those cheap eyeglass repair kits, and the Phillips screwdriver worked perfectly.

Thank you so much iFixit! Very nice guide. Followed and worked like a charm. Keep up the good info coming! Help Translate iFixit. Difficulty Moderate. Steps Time Required 30 minutes.

Mac Mini Core 2 Duo / 2.26 (Late 2009)

Sections 3. Flags 1. Featured Guide This guide has been found to be exceptionally cool by the iFixit staff. Introduction Accessing the RAM requires the removal of the internal frame. At this point, there should be a noticeable gap between the bottom and top housing around the perimeter of the mini.

Welcome to Low End Mac

It may be necessary to wiggle the top housing while lifting it off the bottom housing. If any of the tabs get stuck on the top housing, use the putty knife to free them. Later in this guide you will remove several recessed Phillips screws. Bit drivers are generally too large to fit in the recesses, so be sure to have a thin shafted Phillips screwdriver on hand. First remove the AirPort antenna the larger of the two , located near the power button. Slightly squeeze the two retaining arms toward each other and lift the AirPort antenna off its post.

Squeezing the two posts excessively will surely break them off the internal frame. Work delicately. During reinstallation, you will have to slightly squeeze the two posts together so they fit into the openings on the AirPort antenna board. Use the tip of a spudger to slightly lift the left side of the ZIF cable lock up from its socket. The ZIF cable lock will lift about 1 mm and stop. Do not try to completely remove the ZIF cable lock. If it refuses to lift from its socket, the ZIF cable lock is not fully released. Make sure it is evenly lifted about 1 mm from the socket on the interconnect board.

Use a pair of tweezers to lift the hard drive thermal sensor cable connector up off its socket on the logic board. Use tweezers to grab the connector as seen in the picture , not the wires. The connector is located under the optical drive opening, next to the PRAM battery. In the next few steps, you will remove the four Phillips screws securing the internal frame to the bottom case. Included in each step is an overview picture showing the general location and a closeup showing the actual screw. Remove the recessed Phillips screw near the power button securing the internal frame to the bottom housing.

Remove the recessed Phillips screw near the sleep light securing the internal frame to the bottom housing. This screw is the longest of the four screws securing the internal frame to the bottom case. Remove the Phillips screw near the audio ports securing the internal frame to the bottom case. Gently lift the internal frame up from the bottom housing, minding the AirPort antenna and any other cables that may get caught.

It may be necessary to pull up near the interconnect board to separate it from the logic board. Simultaneously pull the tabs on each side of the RAM chip away from the center of the chip. These tabs lock the chip in place and releasing them will cause the chip to "pop" up. If there are two RAM chips installed, repeat the above procedure for the second chip.

Helpful answers

Cancel: I did not complete this guide. Difficulty Moderate. Steps Time Required


ofmsinelricomp.ml/garfield/bioinformatics-from-genomes-to-therapies.pdf admin